BLOOD SLIDE SMEAR

blood smear,peripheral blood smear,how to make peripheral blood smear,thin peripheral blood smear,how to make a peripheral blood smear,peripheral smears,peripheral blood smear lab,peripheral blood smear hematology,how to make peripheral blood smears with shaky hands,peripheral blood smear pathology,peripheral blood smear examination,peripheral blood smear pathology practical,how to make perfect blood smear,how to make a blood smear


Preparation Of Blood Smaer


Blood Smear in Lab Thin & Thick Peripheral Blood Smear
Blood Slide Semiar

Thick Film:
) Method of making a thick layered film?
It is considered to be a parasite or parasite.
This would appear to be a standard film. (20 WBC) Looking at this film under a microscope, the average
(      Thin Film:
A method of making a thin layer film  
How to prepare blood slides
Check the presence of all the materials to prepare the slide



Special attention should be paid to sterilization
  A new pricker should be used for each person
۔  
Cotton swabs and plain clean water swabs are used
.
The colored finger of the patient's left hand is cleaned with cotton
.
If the finger of the left hand is not available, then blood can be taken from
 the finger of the right hand.
After thorough cleaning with a fingertip sweep, the incision is made about
 one to half a millimeter deep with the help of a perker
.
Slight discoloration of the entire finger. When a drop of blood is collected
,
 it is placed on a slide
In this way three marks are taken on the slide.
Precautions for taking blood from the faeces

The patient's finger should be cleaned thoroughly with a sterile swab to disinfect it.
 A new syringe should be used for each patient and it should be stored after use so that no one gets infected.

If carelessly or irresponsibly used on one of these persons, hepatitis B, AIDS diseases can be transmitted.
The probe should not be inserted too deeply. The wound should be half to one millimeter deep
After taking a drop of blood on a new sterile slide, immediately press the whole finger on the wound with a super swab.

Fragile glass slides should be handled with care and may break and get on your bloody hand while preparing the slide while placing it in the box and removing it.

The first step is to take a blood sample on a glass slide. This blood slide is a diagnosis of malaria or parasite is used for The blood slide is examined under a microscope

There are two types of blood slides

*Thick Film

*Thin Film

To prepare a thick film of blood slide, three drops of blood are taken separately on a glass slideIn these, two drops are made into a circle by extending nine mm from the corner of the second slide.

To make a thin type of blood slide, take a drop of blood on a glass slide and hold it against the edge of another slide (30-25) mm in length and 20 mm in width area is spread on the slide. 

 This thin blood slide is prepared. In which examination is done to identify the parasite

The finger of the patient is pressed with a super sweep.



Thin and thick slides are made according to the instructions and rules


Spread on the slide at a 45-degree angle from the short edge of the other slide, extending in the opposite direction of the angle


Spread the remaining two drops to nine millimeters from the tip of the slide


It should not be rushed or acted upon


In this way, thick and thin film will be prepared





THANK YOU